Philips 8400 series Centrale vapeur haute pression - Manual (Page 8)

Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic
fields (EMF). If handled properly and according to the instructions in this
user manual, the appliance is safe to use based on scientific evidence
available today.
using the appliance
steam ironing
1 Place the steam generator on a stable and level surface, e.g. on the
hard part of the ironing board or on a table.
 Make sure that there is enough water in the water tank.
You can detach the water tank and fill it at any time during use.
Fill the water tank before first use and as soon as the ‘water tank empty’
light flashes.
Do not put hot water, perfume, vinegar, starch, descaling agents, ironing
aids or other chemicals in the water tank.
Note: If the tap water in your area is very hard, we advise you to mix it with an
equal amount of distilled water.
Note: Do not tilt or shake the steam generator when the water tank is full,
otherwise water may spill out of the filling hole.
 Make sure that the water tank is firmly attached to the steam
generator, otherwise the iron does not produce any steam.
 Place the iron resting mat on the ironing board.
5 Slide the carry lock slide to the left to unlock the iron from the
steam generator. Place the iron on the iron resting mat.
6 Put the mains plug in an earthed wall socket and switch on the steam
generator.
7 To set the required ironing temperature, turn the temperature dial
to the appropriate position.
Note: Steam ironing is only possible at higher ironing temperatures
(temperature settings 2 or higher).
8 Turn the power knob to the desired steam setting to switch on the
appliance. Make sure the steam setting is suitable for the selected
ironing temperature.
1 Set to minimum steam (temperature settings 2 to MAX).
2 Set to moderate steam (temperature settings 3 to MAX).
3 Set to maximum steam (temperature setting to MAX).
1
2
1
2
EnGlish
8