Philips Robust Collection Centrifugeuse - Manual (Page 7)

6 Put the lid on the juice jug to avoid splattering. Place the juice jug
under the spout (Fig. 6).
7 Push the spout downwards before you start juicing.
Note: When the spout is in upward position, it functions as a drip stop when the
appliance is switched off. However, if you leave the spout in upward position
during juicing, juice splashes out the spout.
using the appliance
The appliance only functions if all parts are assembled properly and the lid is
properly locked in place with the locking arm.
1 Wash the fruit and/or vegetables and if necessary cut them into
pieces that fit into the feeding tube. (Fig. 7)
2 Slide the foam separator into the juice jug (1) and place the lid on the
juice jug (2). In this way, the foam stays behind in the jug when you
pour out the juice. (Fig. 8)
Note: If you want your drink to have a foamy layer, do not use the foam
separator.
Note: If you want to store the juice in the refrigerator, make sure the lid is on
the juice jug.
3 Make sure the juice jug is placed under the spout and the spout is in
downward position.
4 Turn the control switch to setting 1 (low speed ) or 2 (high speed) to
switch on the appliance. (Fig. 9)
- Speed 1 is especially suitable for soft fruits and vegetables such as
watermelons, grapes, tomatoes, cucumbers and raspberries.
- Speed 2 is suitable for all other kinds of fruits and vegetables.
5 Put the pieces of fruit or vegetables in the feeding tube and gently
press them down towards the rotating filter with the pusher (Fig. 10).
Do not exert too much pressure on the pusher, as this could affect the
amount of juice output.
Tip: The slower you press, the more juice output you get.
EnglisH 7
- Only use the appliance when the locking arm is in locked position.
- Only unlock the locking arm after you have switched off the appliance
and the filter has stopped rotating.
- Do not remove the pulp container when the appliance is operating.
- Always unplug the appliance after use.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic
fields (EMF). If handled properly and according to the instructions in this
user manual, the appliance is safe to use based on scientific evidence
available today.
Preparing for use
1 Wash all detachable parts (see chapter ‘Cleaning’).
2 Unwind the cord from the bottom of the appliance (Fig. 2).
3 Place the juice collector on the motor unit (1). To place the pulp
container, tilt it forwards slightly (2). Insert the top end of the pulp
container first and then push home the bottom end (Fig. 3).
To empty the pulp container while you are juicing, switch off the appliance
and carefully remove the pulp container.
Note: Reassemble the empty pulp container before you continue juicing.
4 Put the filter in the juice collector (1). Hold the lid over the filter and
lower it into position (2) (Fig. 4).
Make sure the filter is fitted securely onto the driving shaft (‘click’).
Always check the filter before use. If you detect any cracks or damage, do
not use the appliance. Contact the nearest Philips service centre or take
the appliance to your dealer.
5 Lift the locking arm to locked position (‘click’). Align the groove in the
pusher with the small protrusion on the inside of the feeding tube
and slide the pusher into the feeding tube (Fig. 5).
Make sure the locking arm is in the locked position.