Smart Technologies SMART Response PE/XE - Manual (Page 2)

2 | QUICK START GUIDE – SMART RESPONSE PE/XE
99-01069-20 A0
Safety and compliance information
WARNING
Failure to follow the installation instructions that ship with the SMART product
could result in personal injury or damage to the product.
CAUTION
Do not open the receiver or clicker units to attempt repairs. Refer all service to
authorized SMART service personnel.
Compliance
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications to this equipment not expressly approved by SMART
Technologies ULC may void the user’s authority to operate this equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Re-orient or move the receiver or clicker units.
– Increase the distance between the other equipment and this product.
– Connect the affected equipment to an outlet on a circuit different from that to
which the receiver’s computer is connected.
– Consult your SMART service representative or an experienced radio/TV
technician for help.