Panasonic DP2000 - Manual (Page 10)

30/05/02 Document Systems Support V1.0
10
Windows NT4/2000
Peer to Peer Printing
You can print to your DP series unit from the above operating systems without the
need of a Server. You can also use this method of printing even if you have a Server
but would prefer to print directly to your DP unit. You may need to have
Administrator access rights to perform the following operations, please consult with
your Network Administrator if you are unsure.
Stage 1
What you will need
Your DP unit will need a TCP/IP address e.g. 192.168.10.1, a sub-net mask e.g.
255.255.255.0 and a gateway address e.g. 192.168.10.100. Your network
administrator may need to give you these addresses. Your PC will also need to have
TCP/IP printing services installed, this is built in to Windows 2000 but not in NT4 so
you may need to load this from your Windows CD ROM. Please consult your
Windows documentation for further information.
Once you have these addresses you will need to input these into the DP unit. Follow
these instructions to input these settings.
1. With the unit turned on press the “function” key located on the dashboard at the
top towards the right.
2. Use the arrow button (DP2500) or the toggle button (DP2000) to select page 2
of the menu.
3. Scroll down to “Key operator code”
4. Input “000” then either OK or SET (if this code is incorrect consult your Dealer)
5. Scroll down until you see “TCP/IP Address”
6. Input the information as requested. Remember to use the full three digit number
for the address e.g. if the address for one segment is “10” input “010”. If you
make a mistake, use the “clear” button to erase your entry. Repeat the above
and the Sub-Net Mask and Gateway.
7. After you have entered the address remember to press the “set” button to
register your entry.
8. After entering all of the information press the “reset” button to get back to the
main menu then switch the unit off and then on for the changes to take effect.
9. You can check to see if your settings have been accepted by going back into the
menu’s previously mentioned.