RocketFish RF-QX4 - Quick Setup Guide - Manual

QUICK SETUP GUIDE
Wireless Bluetooth Headset
RF-QX4 / RF-QX4-T / RF-QX4-E/ RF-QX4-J
Congratulations on your purchase of the RF-QX4 wireless
bluetooth headset. This headset represents the state of the
art in wireless headset design and is designed for reliable
and trouble-free performance.
US: RF-QX4 • Canada: RF-QX4-T • Europe: RF-QX4-E • Japan: RF-QX4-J
Package contents
• RF-QX4 headset
• USB charging cable
and A/C wall adapter
Warning: If the volume is set too high, excessive sound pressure from earphones and
headphones can cause hearing loss.
Features
Charging the battery
Charge the headset before using.
• Connect the charger to the headset and to a power
outlet. While the battery is charging, the indicator
lights red. When the battery is fully charged, the
indicator lights yellow-green.
Note: Charge the headset with the attached USB cable
and provided wall charger only.
Turning the headset on and off
1 To turn on the headset, press and hold the
Power/Send/End button for about two seconds. The
headset beeps and the indicator blinks green.
2 To turn off the headset, press and hold the
Power/Send/End button for about four seconds. The
headset beeps and the indicator briefly lights red.
Pairing the headset
1 Press and hold the Power/Send/End button for about
four seconds. The indicator rapidly flashes green. Make
sure that a compatible phone is turned on and within
33 feet (10 meters) of the headset.
2 Release the button. The headset is now in pairing mode.
3 Activate the Bluetooth connection from the phone.
See your phone‘s documentation for instructions.
4 Set the phone to start searching for Bluetooth devices.
5 Select RF-QX4 from the list of found devices.
6 If necessary, enter the PIN Code 0000 to pair and
connect the headset with your phone. In some
phones, you need to make a connection separately
after pairing.
To... Do this...
Voice dial Press the Power/Send/End button.
Redial Double-press the Power/Send/End button.
Answer a call Press the Power/Send/End button.
End a call Press and hold the Power/Send/End button
for two seconds.
Refuse a call Double-press the Power/Send/End button.
Change the volume Press the + (volume up) or – (volume down) button.
Transfer a call between Double-press the Power/Send/End button
connected devices while in a call to transfer the call to the handset.
Volume
down
Volume
up
Earpiece
Power/Send/
End button
Indicator
light
Charger
connector
• Quick Setup Guide
• Ear loop
• Small, medium
and large ear buds