Century Systems CFD-4306 - Manual (Page 21)

18
3-7. Extended Memory Installation
1. Open the top cover by pressing the
Cover Open Buttons on both sides.
2. Take off the media roll spindle. Open
and remove the plastic cover on the
inner base.
3. Secure the PCB pillar onto the main
board.
4. Check the pins where the memory is
to be connected to, then plug the
memory card onto the main board.
Note: Please make sure the aperture on
the connector and the pins match,
otherwise when too much force is
applied onto the memory card,
there’s a possibility that the pins
may get damaged.
5. Close the plastic memory cover.