Century Systems CFD-4306 - Manual (Page 27)

24
4-7. Error Messages
LED Light LED
Message
Ready Status
Beep Description Solution
Print head is
opened
Red
4 beeps
twice
Print head not firmly in place.
Re-open print head and make
sure it closes tightly.
Entering the
Cooling Process
Red None Print head temperature high.
When print head temperature
drops to the normal
temperature range, printer will
go back to the standby mode.
Ribbon not installed, and printer
shows error message. Make sure the printer is in the
Direct Thermal mode.
Out of ribbon or
check ribbon
sensor
Red
3 beeps
twice
Ribbon used up or ribbon supply
shaft not moving.
Replace with new ribbon roll.
Unable to detect paper.
Make sure the movable sensor
mark is at the correct position,
if the sensor is still unable to
detect paper, and then go
through Auto Sensing again.
Out of media or
check media gap
sensor
Red
2 beeps
twice
Paper used up. Replace with new label roll.
Check paper
setting
Red
2 beeps
twice
Abnormal paper feed.
Possible causes: card tags or
paper fall into the gap behind
the platen roller, can’t find
label gap/black mark, black
mark paper out. Please
adjust according to actual
usage.
Command is not
recognized
Red
2 beeps
twice Wrong command; printer prints
out “Command is not recognized.”
Check printer commands,
possible value missing or
errors.
Memory is full Red
2 beeps
twice Memory is full; printer prints out
“Memory full.”
Delete unnecessary data in
the memory or purchase
extended memory (options).
Filename can not
be found
Red
2 beeps
twice Can’t find the file; printer prints
out “Filename can not be found.”
Use “~X4” command to print
out all the files, then check
whether the file exist and the
names are correct.
Filename is
repeated
Red
2 beeps
twice File name is repeated; printer
prints out “Filename is repeated.” Change the file name and
download again.