Century Systems CFD-4306 - Manual (Page 29)

26
5-3. Print Line Adjustment
Use print head adjusting gear to adjust the contacting
surface between print head and label. To get better
printing balance and quality.
1, When turning print head adjusting gear counter-
clockwise (as arrow 1 shows), print head would move
in a direction where arrow A is.
2. When turning print head adjusting gear clockwise
(as arrow 2 shows), print head would move in a
direction where arrow B is.
5-4. Adjust the cutter
1. A cutter-adjusting hole is present on both sides
(where A is pointing to).
2. The cutter will not function properly if there is a
paper jam. Turn the power off and use a #M3
hexagon wrench inserted into hole “A” and open the
cutter from right to left.
3. Power on the printer after clearing the paper jam,
the cutter will return to the correct position
automatically.
Note: The label / paper used for cutting is suggested to
be at least 30mm in height.