Brother NC-9100H - Manual (Page 94)

FRONT PANEL SETUP MENU 10 - 5
IP Address
This field displays the current IP address of the DCP/MFC. If you
have selected a BOOT Method of STATIC, enter the IP address that
you wish to assign to the DCP/MFC (check with your network
manager for the IP address to use). If you have selected a method
other than STATIC, the DCP/MFC will attempt to determine its IP
address using the DHCP or BOOTP protocols. The default IP
address of the Brother network board in your DCP/MFC will probably
be incompatible with the IP address numbering scheme of your
network. We recommend that you contact your network manager for
an IP address for the network the unit will be connected on.
1 (For MFC) Press Menu , 6 , 1 , 2 .
(For DCP) Press Menu , 4 , 1 , 2 .
2 Select 1 to change. Enter the IP address.
3 Press Set .
4 Press Stop/Exit .
Subnet Mask
This field displays the current subnet mask used by the DCP/MFC. If
you are not using DHCP or BOOTP to obtain the subnet mask, enter
the desired subnet mask. Check with your network manager for the
subnet mask to use.
1 (For MFC) Press Menu , 6 , 1 , 3 .
(For DCP) Press Menu , 4 , 1 , 3 .
2 Select 1 to change. Enter the Subnet Mask address.
3 Press Set .
4 Press Stop/Exit .
When the BOOT METHOD is set to “AUTO”, the DCP/MFC
cannot receive IP address from a BOOTP server in
Windows
® 2000. So please ensure that you use DHCP for
Windows ® 2000 server.