Heater Craft 900S Series Shower - Manual (Page 5)

Shower Valve/Unit Installation
4
Important Note: In most applications the spray hose will be fed back into the box, so consider the
coiling of the hose when not in use. It should coil away from moving parts and high heat sources like
the engine exhaust manifolds, sharp edges or objects that may kink, pinch or restrict the travel of the
hose in any way.
1. Determine the location for the shower valve/unit. Consider the routing of the water hoses and wiring.
100-S Series– The S-102 valve should not be installed on or near high heat sources such as
engine exhaust manifolds. the valve should also be accessible for adjustment.
2. Secure the valve in place.
The S-110 valve can be mounted through a bulkhead or flat surface.
The valve should also be accessible for adjustment.
– Surface Mounting of valve.
A flat surface area of 3"x8" is needed for proper installation.
2. Cut a rectangular opening 7" x 2". Mark the mounting holes and pre drill using 7/64" drill bit.
3. Mount the valve in place.
300-S and 400-S Series– A flat surface area of 6" x 10-1/2" with 5" of depth is necessary for
proper installation.
2. Cut a 4-5/8" x 9-1/4" rectangular opening. Mark the mounting holes and pre drill using 7/64" drill bit.
600-S Series– A flat surface area of 4" x 4" with 10" of depth if handle is straight out from
bottom of cup or 5" of depth if using 45
° cup, is needed for proper installation.
2. Cut a 2.35" round opening. Mark the mounting holes and pre drill using 7/64" drill bit.
600-C Series– A flat surface area of 3-3/4" x 3-3/4" with 8" of depth is needed for proper
installation.
2. Cut a 2-1/2" round opening. Mark the mounting holes and pre drill using 7/64" drill bit.
800-S Series– A flat surface area of 8" x 5" with 6" of depth is needed for proper installation.
2. Cut a oval opening using provided template. Mark the mounting holes and pre drill using 7/64" drill bit.
900-S Series– A flat surface area of 11" x 5" with 6" of depth is needed for proper installation.
2. Cut a oval opening using provided template. Mark the mounting holes and pre drill using 7/64" drill bit.
3. Apply a thin line of sealant around the unit, if necessary (3M 5200 Marine Sealant is recommended).
4 Mount the unit in place.
Questions?
Call For Technical Support
(208) 687-4400 or
Fax (208) 687-9700
www.heatercraft.com