Poison Spyder JK EVAP SKID - Manual

©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
INSTALLATION INSTRUC
TIO
NS
Thank you for purchasing a Poison Spyder JK
Evap Skid. The Skid will protect your Jeep’s
vulnerable evaporative canister from damage
on the trail. Note that the installation procedure,
brackets and hardware are different for ‘07-’11
and ‘12+ JK’s (hardware and instructions for both
are included). Installation is fairly simple with
the right tools and good mechanical abilities. If
you are not confident in your mechanical skills,
please seek the help of a professional to perform
the installation. Please read through these entire
instructions before proceeding with installation.
PARTS LIST
Please check your packages immediately upon
arrival to ensure that everything listed is included,
and to check for damage during shipping. If
anything is missing or damaged, call Poison
Spyder at (951) 849-5911 as soon as possible.
(1) JK Evap Skid
‘12+ INSTALL KIT:
(1) 12+ Front Hold-Down Bracket
(1) 5/16 X 3/8 Nylon Spacer
(1) 5/16-18 X 1 SS Flat Head Cap Screw
(1) 5/16-18 Nylon Insert Lock Nut
(1) 5/16 Flat Washer
‘07-’11 INSTALL KIT:
(1) 07-11 Front Hold-Down Bracket
(2) 07-11 Rear Hold-Down Strap
(1) 3/8-16 X 1-1/2 Gr.8 Hex Head Cap Screw
(1) 3/8-16 Nylon Insert Lock Nut
(2) 3/8 Flat Washer
TOOLS NEEDED
• Small flat screwdriver or pick (07-11)
• 9/16” end wrenches (2) (07-11)
• Needle-nosed pliers (12+)
• 3/16” Hex key or driver bit (12+)
• 1/2” end wrench (12+)
• 13mm (12+) & 16mm end wrenches
• 13mm (12+) & 16mm sockets & ratchet
NOTE: Parts and procedures are provided for
installing the JK Evap Skid in either ‘07-’11 or
‘12+ model year Jeep JK’s. Use the parts and
tools from the lists above, and the procedure
below, that correspond to your specific year
model.
‘07-’11 INSTALLATION PROCEDURE
1. Park vehicle on a level surface, place the
transmission in gear or park, and set the
emergency brake. Wear safety glasses from
this point on.
2. Use a small flat screwdriver or pick to
disengage and unplug the two line lines
at the back of the canister. Each of these
connections has a wire spring/bail that can
be pried up to release it from its socket.
Work the vapor line loose from its fitting. It is
just a slip-fit but can be on there pretty tight.
JK EVAP SKID INSTALL INSTRUCTIONS
‘12+ INSTALL KIT ‘07-’11 INSTALL KIT JK EVAP SKID