Poison Spyder TJ A-PILLAR LIGHT BAR MOUNTS FOR RIGID 50 LED User Manual

Installation instruc tio ns, Tj a-pillar light bar mounts for rigid 50” led

Advertising
background image

©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM

INSTALLATION INSTRUC

TIO

NS

TJ A-PILLAR LIGHT BAR MOUNTS FOR RIGID 50” LED

Thank you for purchasing Poison Spyder

products for your Jeep. Installation is fairly simple

with the right tools and good mechanical abilities.

If you are not confident in your mechanical skills,

please seek the help of a professional to perform

the installation. Please read through these entire

instructions before proceeding with installation.
IMPORTANT: Completely install and remove

these items prior to painting or powder coating.

This will allow you to check for fitment or do any

clearancing or fitting ahead of time, to reduce

the chance of damage to the finish during final

installation. Poison Spyder Customs Inc. is not

responsible for costs for or damage to paint or

powder coat finish under any circumstances,

including paint or powder coat of incorrectly

shipped or defective parts.

PARTS LIST
Please check your packages immediately upon

arrival to ensure that everything listed is included,

and to check for damage during shipping. If

anything is missing or damaged, call Poison

Spyder at (951) 849-5911 as soon as possible.

(1) Driver Side TJ A-Pillar Light Bar Mount
(1) Passenger Side TJ A-Pillar Light Bar

Mount

(1) Driver Side TJ A-Pillar Rubber Liner
(1) Passenger Side TJ A-Pillar Rubber Liner
(6) 5/16-18 X 1 SS Button Head Cap Screw

INSTALLATION NOTES

If the Light Bar Mounts were received bare,

they will need to be painted or powder coated

prior to final installation. However it is a good

idea to test-fit prior to paint, in order to ensure

proper fitment to ensure against damage to the

paint or powder coat upon final installation.

Remove the three factory bolts at the

lower corners of the windshield brackets that

correspond to the holes in the mounts. Do not

remove the lower-most bolt on each side—

leave those in place while installing the light

bar mounts.

Place the supplied rubber liners between the

mounts and the Jeep’s A-pillar before bolting

them on. Use the supplied 5/16-18 X 1 SS

Button Head Cap Screws to secure the mounts

to the Jeep. Make alignment adjustments to

the rubber liners as the bolts are tightened.

Install the light bar into the tabs at the top

of the mounts AFTER the mounts have been

installed on to the Jeep. It may be necessary

to loosen the mount bolts slightly in order to

slide the light bar studs into the slots. Once

everything is installed and aligned, re-tighten

all hardware.

This product is designed exclusively for

mounting the Rigid Industries 50” E-Series or

SR-Series LED light bars. No guarantee is

made regarding fitment of other brands of light

bars.

Routing of electrical cables is left to the

installer’s discretion. We have seen several

different methods of routing the cable, we

encourage you to do a search on the web for

ideas and tips for routing the cables.

With the SR-Series (single row) light bar, If

the light bar produces an annoying whistle or

harmonics at highway speeds, try flipping it

over. We have had the best results with the

light bar flipped so that the cables route down

the driver’s side.

Advertising