J.P. Instruments EDM 960 Twin Primary Installation Manual User Manual
The owner of the edm-960 must keep this manual
FAA Approved Installation Manual for the EDM-960 Report No 909
Primary Engine Data Management System Page 1 of 46 Rev D
Date 2-6-2014
TABLE OF CONTENTS
1.
Revisions _____________________________________________________________________________2
2.
Read This First ________________________________________________________________________2
3.
Instrument Marking_____________________________________________________________________3
4.
Primary TSO Label _____________________________________________________________________3
5.
Operation and Abbreviations_____________________________________________________________4
6.
Dimming______________________________________________________________________________5
7.
Locating and Installing the Indicator and Remote Alarm Display, RAD __________________________6
8.
EDM-960 Display Installation _____________________________________________________________7
9.
EDM-960 Key Card Installation ___________________________________________________________8
10.
EDM-960 in aircraft with wing-mounted engines _____________________________________________9
11.
EDM-960 in aircraft with centerline thrust engines __________________________________________10
12.
Wiring harness for 950 _________________________________________________________________11
13.
Wiring harness for Display _____________________________________________________________11
14.
Pressurized Aircraft wire Routing ________________________________________________________12
15.
Power Connection ____________________________________________________________________12
16.
Probe Wiring _________________________________________________________________________12
17.
Wiring Markings ______________________________________________________________________13
18.
Exhaust Gas Temperature Probe (EGT) Installation _________________________________________13
19.
Turbine Inlet Temperature (TIT) Probe Installation (optional) _________________________________14
20.
Cylinder Head Temperature (CHT) Probe Installation ________________________________________14
21.
Outside Air Temperature (OAT) Probe Installation __________________________________________15
22.
Compressor Discharge Temp Probe Installation (optional) ___________________________________15
23.
Carburetor Probe Installation (optional) ___________________________________________________15
24.
Oil Temperature Probe Installation _______________________________________________________15
25.
Oil Pressure Sensor Installation _________________________________________________________15
26.
Ammeter Shunt Installation _____________________________________________________________17
27.
General Fuel Flow Transducer Installation_________________________________________________18
28.
Fuel Level Interface Installation _________________________________________________________19
28.3
Fuel Tank Calibration __________________________________________________________________21
29.
Capturing the sender reading at each calibration point: _____________________________________22
30.
GPS Interface ________________________________________________________________________25
31.
Manifold Pressure (MAP) Sensor ________________________________________________________26
32.
RPM Sensor installation________________________________________________________________27
33.
EDM-960 system Specifications and Limitations____________________________________________28
34.
EMI Radio Test: _______________________________________________________________________29
35.
Component Parts List__________________________________________________________________30
36.
Weight and Balance Data _______________________________________________________________32
37.
Pilot Programming ____________________________________________________________________32
38.
Programming the K factor ______________________________________________________________35
39.
Trouble Shooting _____________________________________________________________________36
40.
Connector Pin Assignments EDM-950, J1 through J5 _______________________________________37
41.
P8 Harness Display PN 790807 __________________________________________________________43
42.
Interconnection between Display, DAU’s and GPS __________________________________________46
43.
Instructions for Continued Airworthiness (ICA) ___________________________________________46
The Owner of the EDM-960 must keep this manual
J.P. INSTRUMENTS
PO BOX 7033
HUNTINGTON BEACH CA
Last printed 5/8/2014 1:08:00 PM