Lull 1044C-54 Series II Service Manual User Manual
Page 355
Axles and Brakes
31200079
9-11
6. Apply grease to grease fitting on slip yoke.
Drive Shaft Installation
Important: To help ensure optimum performance, the drive shaft assemblies are
specially balanced as a unit at the factory. When servicing any flange
yoke, slip yoke or drive shaft tube, order a complete assembly if
components are bent or damaged. Refer to the appropriate parts
manual for ordering information.
Transmission-to-Axle Drive Shafts
1. Raise the drive shaft assembly into position. The slip-yoke end of the
drive shaft mounts toward the axle. If reinstalling a drive shaft
previously removed, align the flange yokes according to the alignment
marks made during removal.
Important: Yokes at both ends of the drive shaft must be in the same plane to
help prevent excessive vibration.
2. Install the four capscrews and two straps securing the bearing crosses
to the transmission. Torque the capscrews to 60 lb-ft (81 Nm).