Lull 1044C-54 Series II Service Manual - Manual (Page 52)

General Maintenance
3-8 31200079
Cleaning Decals
If soiled with dirt, clean decals with mild soap. Use a mild alcohol solution if
soiled with grease. Do not use solvents that may damage the decal.
Replace all damaged, missing, or painted decals that cannot be read. On
refurbished or replaced parts, all missing decals must be replaced.
See your JLG dealer for replacement decals and placards.
Attaching Decals
The surface on which a decal is to be attached must be dry and free of all
dirt and grease. Remove the backing from the decal and apply decal in its
correct location. Once in place, rub entire surface of the decal with your
thumb, applying sufficient pressure to ensure good adhesion of the decal
to the mounting surface.
Storage
The following procedures are to be used if the machine will not be
operated for a long period of time.
Preparing the Machine for Long-Term Storage
Prior to placing the machine into storage, perform the following:
1. Wash off the entire machine.
2. Lubricate all grease fittings as instructed in “Grease” on page 3-6 of
this section
3. Change engine oil according to specifications described in Table 3-2
on page 5.
4. Apply grease to all exposed hydraulic cylinder rod areas.
5. Disconnect battery cables. If the machine is to be stored under cold
conditions, remove the battery and store it in a heated area.
6. Check engine coolant level and make sure it has an adequate coolant-
to-water ratio for the conditions it will be stored in.
7. Check transmission fluid level and fill if necessary according to the
guidelines described in Table 3-3 on page 5 of this section.
8. Preferable, store the machine inside where it will remain dry. If it must
be stored outside, park it on a concrete slab or on lumber laid on flat,
level ground and cover it with a tarp.