Lull 944E-42 Operation Manual - Manual (Page 67)

Section 4 - Operation
4-7 31200354
Placing a Load
Before placing any load be sure that:
• The landing point can safely support the weight of the load.
• The landing point is level; front to back and side to side.
• Use the capacity chart to determine safe boom and transfer carriage extension
range. See “Use of the Capacity Chart” on page 5-5.
• Align forks at the level load is to be placed, then position boom slowly until load is
just above area where it is to be placed.
• Lower the boom until the load rests in position and the forks are free to retract.
• The transfer carriage can be used to place the load onto the landing point, being
certain the load is within the transfer limits.
Disengaging a Load
Once the load has been placed safely at the landing point, proceed as follows:
1. With the forks free from the weight of the load, the boom or transfer carriage can
be retracted.
2. Lower the carriage.
3. The telehandler can now be driven from the landing location to continue work.