Road Armor 1994-2002 Dodge 2500,3500 Front Bumper - Manual

Warning!
Read the instructions completely before beginning the installation. Before tightening bolts, drilling or
cutting where required, check to make sure that there are no obstructions such as brake, fuel or electri-
cal lines that may be damaged. Also keep in mind this is an aftermarket product and MAY require some
minor shimming and or trimming, reaming etc. to fit properly.
IMPORTANT NOTICE
IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED.
BE SURE TO INSPECT AND OR TEST FIT YOUR PRODUCT TO ENSURE PROPER FITMENT AND ADEQUATE SURFACE PREPARATION BEFORE
HAVING YOUR PRODUCT COATED, PAINTED, BED LINED, ETC.
ROAD ARMOR WILL NOT BE RESPONSIBLE FOR THE COST OF COATING YOUR UNIT IF ANY PROBLEMS WITH FIT OR FINISH ARE NOT
NOTED AND ADDRESSED PRIOR TO HAVING YOUR PRODUCT COATED.
THANK YOU
SUGGESTED LIGHTS THAT FIT THIS UNIT:
PIAA 510 - www.piaa.com - Part Numbers (5161, 5164, 5192, 5190, 5196).
Warn 350F - www.warn.com Part Number (82410).
TOOLS NEEDED
-Yourself and a strong friend / bumper jack.
( Don’t worry, we’re not calling you or your friend a “tool” )
- Socket set, Ratchet & Wrenches (metric & standard)
( ... more than likely metric for your rig, cause everything’s imported these days,
and standard for your new bad ass Made in USA bumper.
Road Armor thanks you for supporting the American Economy! )
-Cut off wheel or some type of tool to cut threw 1/8” plastic sheet
- Common Sense a Tape Measure and a bit of Patience
( And also a cold drink to celebrate afterwards )
1994-2002 Dodge
2500/3500
Front Bumper
Install
Instructions