Road Armor 2002-2009 GMC Topkick Front Bumper - Manual

2002 - 2009 CHEVY KODIAK
/
GMC TOPKICK
FRONT BUMPER
INSTALL INSTRUCTIOND
Warning!
Read the instructions completely before beginning the installation. Before tightening bolts check to make
sure that there are no obstructions such as brake, fuel or electrical lines that may be damaged. Also keep
in mind this is an aftermarket product and MAY require some minor shimming and or trimming, reaming
etc. To fit properly.
IMPORTANT NOTICE
IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED.
BE SURE TO INSPECT AND OR TEST FIT YOUR PRODUCT TO ENSURE PROPER FITMENT AND ADEQUATE SURFACE PREPARATION BEFORE
HAVING YOUR PRODUCT COATED, PAINTED, BED LINED, ETC.
ROAD ARMOR WILL NOT BE RESPONSIBLE FOR THE COST OF COATING YOUR UNIT IF ANY PROBLEMS WITH FIT OR FINISH ARE NOT
NOTED AND ADDRESSED PRIOR TO HAVING YOUR PRODUCT COATED.
THANK YOU
SUGGESTED LIGHTS THAT FIT THIS UNIT:
One Set of PIAA 510 - www.piaa.com - Part Numbers (5161, 5164, 5192, 5190, 5196).
OR
Warn 350F - www.warn.com Part Number (82410).
One Set of PIAA 540 - Part Number (5461, 5462)
TOOLS NEEDED
-Yourself and a few strong friends / bumper jack.
( Don’t worry, we’re not calling you or your friends a “tool” )
- Socket set, Ratchet & Wrenches (metric & standard)
( ... more than likely metric for your rig, cause everything’s imported these days,
and standard for your new bad ass Made in USA bumper.
Road Armor thanks you for supporting the American Economy! )
- Common Sense a Tape Measure and a bit of Patience
( And also a cold drink to celebrate afterwards )