Road Armor 2007-2011 Toyota Tundra Front Bumper User Manual

Road Armor For the car

Advertising
background image

Warning!

Read the instructions completely before beginning the installation. Before tightening bolts, drilling or

cutting where required, check to make sure that there are no obstructions such as brake, fuel or electri-

cal lines that may be damaged. Also keep in mind this is an aftermarket product and MAY require some
minor shimming and or trimming, reaming etc. to fit properly.

IMPORTANT NOTICE

IF YOU ARE RECEIVING THIS ROAD ARMOR PRODUCT RAW/UNCOATED.

BE SURE TO INSPECT AND OR TEST FIT YOUR PRODUCT TO ENSURE PROPER FITMENT AND ADEQUATE SURFACE PREPERATION BEFORE

HAVING YOUR PRODUCT COATED, PAINTED, BED LINED, ETC.

ROAD ARMOR WILL NOT BE RESPONSIBLE FOR THE COST OF COATING YOUR UNIT IF ANY PROBLEMS WITH FIT OR FINISH ARE NOT

NOTED AND ADDRESSED PRIOR TO HAVING YOUR PRODUCT COATED.

THANK YOU

SUGGESTED LIGHTS THAT FIT THIS UNIT:

PIAA 510 - www.piaa.com - Part Numbers (5161, 5164, 5192, 5190, 5196).

Warn 350F - www.warn.com Part Number (82410).

TOOLS NEEDED

-Yourself and a strong friend / bumper jack.

( Don’t worry, we’re not calling you or your friend a “tool” )

- Socket set, Ratchet & Wrenches (metric & standard)

( ... more than likely metric for your rig, cause everything’s imported these days,

and standard for your new bad ass Made in USA bumper.

Road Armor thanks you for supporting the American Economy! )

-Rivet Remover

(makes it easy and doesn’t damage the rivets) you will be keeping these and putting them back in so be careful!

See picture two if your not sure what the tool looks like

- Common Sense a Tape Measure and a bit of Patience

( And also a cold drink to celebrate afterwards )

2007 - 2011

TOYOTA TUNDRA

FRONT INSTALL

INSTRUCTIONS

Advertising