Mountain Off Road LS9081 User Manual

Installations instructions for m.o.r.e.™ ls9081

Advertising
background image

MOUNTAIN OFF ROAD ENTERPRISES, LLC.

P.O. BOX 690 DELTA COLORADO 81416

970-625-0500

970-625-3747 FAX

E-mail: [email protected]

www.mountainoffroad.com

INSTALLATIONS INSTRUCTIONS for M.O.R.E.™ LS9081

This is the proper location for the
bolt-in center brace. The long leg up,
center brace forward. This way, the
shackle can clear the rear crossmem-
ber on suspension compression.

Rear frame crossmember

The “Boomerang” shackles fit the front or rear of your Jeep® YJ Wrangler. The above pictures show the proper
way to install them. After removing the stock shackles, install the Boomerang shackles as shown in the picture(s)
above. Torque the bolt-in center brace bolt/nut to 55 Lb. Ft. torque. Tighten the greaseable shackle bolts to 30
Lb. Ft. torque. Lube with your favorite chassis grease.




TERMS-POLICIES:

DAMAGE CLAIMS: All orders are carefully packed, however, mishandling by the carrier can result in damage. The carrier has the responsibility for the shipment
from the time it leaves our warehouse until it is delivered to you. All claims for lost or damaged goods should be reported to the carrier, not to M.O.R.E.™ LLC.

RETURNS: No returns will be accepted without prior permission from M.O.R.E.™ LLC. After you receive a Return Goods Authorization (RGA) number, merchan-
dise must be returned prepaid and insured. A claim must be made with in 30 days from receipt of merchandise. The original invoice or a copy with the RGA num-
ber written on must accompany all returns. A 20% restocking fee will be charged on all parts returned for credit or refund unless merchandise is proven to be
defective or was shipped wrong by M.O.R.E.™ LLC. No merchandise will be issued credit or refund if it has been installed, modified, used in any way or is in
unsalable condition.

WARRANTY: All merchandise is warranted to be free from defects in materials and workmanship prior to installation. Any alteration or improper use will void this
warranty. Because all parts we sell are intended for use in heavy-duty applications it is not possible to warrantee or guarantee the performance of any items.
M.O.R.E.™ LLC. products and the products manufactured by others, which we sell may be subject to an infinite variety of conditions due to the manner in which
they are used, serviced and/or installed. Purchasers and users of such products rely upon their own judgment as to the suitable use selection, service and instal-
lation of such products.

PRODUCT DISCLAIMER: Modification of your vehicle to enhance performance with parts sold by M.O.R.E. LLC. may create a dangerous condition which
could cause serious bodily injury, and the buyer hereby expressly assumes all risks associated with any such modifications. All parts sold by M.O.R.E.™ LLC.
are for racing or off road use only. Mountain Off Road Enterprises LLC. will not accept responsibility for personal injury or property damage arising from the failure
of any parts manufactured or sold by M.O.R.E.™ LLC.

Specifications are subject to change without notice.

Jeep®, AMC®, CJ®, YJ®, Wrangler®, are registered trademarks of DaimlerChrysler. M.O.R.E.™ is not affiliated with DaimlerChrysler.

M.0.R.E™, BombProof™, S.R.S.™, SlipLoc™, DoubleJointed™, RockProof™, are trademarks used by Mountain Off Road Enterprises, LLC. copyright©,
1999-2008.


This is the proper
way to install the
shackles on the
FRONT of the YJ.
The

long

leg

down,

bolt-in

c e n t e r

b r a c e

back. This way, it
acts as a “Anti-
K i c k - B a c k ”
shackle.

Contents of LS9081:

4-side plates

2-center braces

4-drilled sleeves

4-drilled shackle bolts

2-center brace bolts

6-crimp-loc nuts

8-polyurethane bushing halves

Advertising