Synergy 8082 - Jeep JK Brake Line Relocation Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
8082 JEEP JK BRAKE LINE RELOCATION BRKT
GENERAL NOTES:

These instructions are also available on our website; www.synergymfg.com. Check the website before
you begin for any updated instructions and additional photos for your reference.

These brake line relocation brackets are designed for a maximum of 3.0” lift heights. Use Synergy
extended brake lines 8066 for lifts above 3.0”

Upon installation, be sure to droop out suspension to check for adequate brake line length.
PARTS LIST:

8083 – FRONT JEEP JK BRAKE LINE RELOCATION KIT
 (2) 808301 Front brake line relocation bracket
 (2) 1/4”-20 UNC x 3/4" long hex head bolts
 (2) 1/4”-20 UNC nylock nuts
 (4) 1/4" GR8 flat washers

8084 –REAR JEEP JK BRAKE LINE RELOCATION KIT
 (2) 80840 Rear brake line relocation bracket
 (2) 1/4”-20 UNC x 3/4" long hex head bolts
 (2) 1/4”-20 UNC nylock nuts
 (4) 1/4" GR8 flat washers
Parts / Tools Needed to complete installation:

Basic simple hand tools. Sockets / combo wrenches.
INSTALLATION:
1) Begin with the front brake lines by removing the factory bolt securing the brake line to the frame. Use a
10mm socket or combo wrench.
2) Install front brake line relocation bracket as pictured below. Note the brackets are left and right specific
and should jog out as pictured. The notch in the 808301 relocation bracket should be towards the front
of the vehicle.