Synergy 8094 - Jeep JK Steering Stabilizer Mount (RHD) - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PM-8094 JK STEERING STABILIZER RELOCATION
BRACKET, RIGHT HAND DRIVE
Version 1
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• This steering stabilizer bracket will only work with the stock track bar bracket
with out a track bar relocation bracket.
• This steering stabilizer bracket enables the use of the Fox 980-99-099-A-JK
steering stabilizer, Synergy Suspension PPM-6001 steering stabilizer or the
factory steering stabilizer. Others most likely can be used but you will be
required to check fitment.
• A minimum of 1” tall bumper stop spacers are required to prevent the steering
stabilizer relocation bracket from contacting the frame when the suspension is at
full bump. Most lift kits include and require a bump stop spacer this tall.
• This bracket requires the use of PPM-8003 steering stabilizer clamp for proper
installation.
1. Turn the wheels all the way to the left
2. Remove the factory steering stabilizer
3. Remove the track bar bolt. It helps to have some one else turn the steering wheel side
to side slightly to align the track bar bolt to the hole.
4. Install the new steering stabilizer relocation bracket under the track bar mounting bolt
on the factory axle bracket. Loosely tighten the track bar bolt nut to hold the steering
stabilizer relocation bracket into place.