Synergy 8557/8558 - Dodge Steering Box Brace (94-08) - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
8557-04, 8558-04, DODGE 94-08 STEERING BOX BRACE
GENERAL NOTES:

These instructions are also available on our website at www.synergymfg.com. Check the website for any
updated instructions and additional photos for reference.

This bracket is designed to be bolt on with no modifications. Install time should be from 1-2 hrs tops.

Thoroughly read all instructions before beginning installation.
PARTS LIST:

1 - 8557 Dodge Steering box brace

1 - Pillow bearing

2 - 7/16-14 UNC 1.50” long bolt

2 - 7/16-14 UNC Nylock nut

4 - 7/16” flat washers

4 - M10-1.50 x 35mm Gr 8.8 bolts

4 - 3/8” flat washers

4 - 3/8” lock washers
Parts / Tools Needed to complete installation:

Basic simple hand tools.

1-3/4” open end wrench or large adjustable wrench to accommodate pitman arm bearing stud

Hammer & punch
APPROXIMATE INSTALL TIME: 1-2 HOURS
INSTRUCTIONS:
1) Begin by removing the bolts holding the sway bar clamps to the frame and rotate the sway bar down as
pictured below.