Snorkel MHP35 - Manual (Page 34)

7. Daily Inspection and Maintenance
At the start of each work day (or 8 hour shift), an
MHP13/35 qual i fied op er a tor must per form the
Daily In spec tion and Main te nance as listed in the
ta ble be low.
The pur pose of the Daily In spec tion and Main te -
nance is to keep the MHP13/35 in proper work ing
con di tion and to de tect signs of mal func tion at the
ear li est pos si ble time.
The MHP13/35 should be in the STOWED
POSITION and the Mas ter Key Switch set to OFF
be fore you be gin this in spec tion.
De fec tive parts and/or equip ment mal func tions
jeop ar dize the safety of the op er a tor and other per -
son nel, and can cause dam age to the ma chine.
The potential for an accident increases when
operating an MHP that is damaged or
malfunctioning. Death or serious injury can
result from such accidents. Do not operate
an MHP that is damaged or malfunctioning.
MHP13/35 – 12431A page 7 - 1
Item Service Required
Engine fuel level Look to see that the fuel tank is full
Fuel tank cap Check to see that the cap is tight
Engine oil level Check oil level (between dipstick lines)
Fuel leaks Visually inspect (hoses and connections)
Operator's manual Check that it is in the holder on the machine
Wiring harnesses Visually inspect (installation, condition)
Battery terminals Visually inspect (no corrosion)
Battery fluid level Check fluid level (1/4" or 6 mm below filler neck)
Hydraulic oil level Visually inspect level (between lines on gauge)
Hydraulic oil leaks Visually inspect (hoses, tubes)
Tires and wheels Visually inspect (condition)
Bolts and fasteners Visually inspect (condition)
Structural damage and welds Visually inspect (weld cracks, dents)
Lanyard anchor points Visually inspect (condition)
Platform gravity gate Check condition and operation
Platform guardrails Visually inspect (condition)
Flashing light (option) Visually inspect (operation)
Ground control switches Actuate and inspect for proper operation
Level sensor (option) Check operation
Emergency lower Check operation (causes correct motion)
Platform control box switches Actuate and inspect for proper operation
RCD/ELCB AC outlet (option) Check operation
Platform work lights (option) Check operation
Placards and decals Visually inspect (installation, condition)
■ Daily Inspection and Maintenance Table
WARNING