Aerovent IM-205 - Manual

PARTS
A - Flat Washer — Stainless steel
B - Shaft Key — Stainless steel
C - Lock Washer — Stainless steel
D - Hex Head Bolt, R.H. Thread — Stainless steel
E -
1 ∕
8
" Minimum Gap — Between end of shaft and
washer
F - Flat Washer — Stainless steel
G - Shaft Turndown —
1 ∕
8
" on shaft diameter through
3 ∕
4
"; 1 ∕
4
" on shaft diameter 1" and larger.
ASSEMBLY
1. 10 ga. stainless steel washer (A) must be placed on shaft.
2. Insert key in keyway.
3. Align keyway in propeller hub with key on shaft, and push
propeller onto shaft.
4. Place second stainless steel 10 ga. washer on shaft. Must
have 1 ∕
8
" minimum gap. If gap is less than 1 ∕
8
", add a second
washer (A).
5. Place stainless steel lock washer (C) on hex head. Bolt and
tighten securely.
6. Rotate propeller by hand to check tip clearance of propel-
ler blades to fan housing.
Fiberglass Propeller Assembly Instructions
A
B
C
D
E
F
G
©1997 Aerovent
General Installation, Operation and Maintenance Instructions For Aerovent Products
IM-205
June 1997
Aerovent | www.Aerovent.com
5959 trenton Lane n | minneapolis, mn 55442 | Phone: 763-551-7500 | Fax: 763-551-7501
®