Eppendorf New Brunswick Shaker Operating Key - Manual

www.eppendorf.com
To set and start a timed run:
1. Press SELECT until HRS lights.
2. Press
or to set time (between 0.1 HRS and 99.9 HRS).
3. While SET is lit, press START/STOP. TIME will light and Display will
show time remaining.
To cancel:
1. Press SELECT to HRS.
2. Press
or , then START/STOP. Time light turns off. Display reads
“Off”.
Audible alarm:
1. Press SELECT to acknowledge. Stops sounding, but
remains enabled.
2. To deactivate, SELECT to HRS, then press
and
SIMULTANEOUSLY , then press START/STOP. MUTE will light.
3. To reactivate, SELECT to HRS, then press
and
SIMULTANEOUSLY, then press START/STOP. MUTE will go off.
Total running time:
1. Press SELECT to HRS.
2. Press
and SIMULTANEOUSLY.
3. Press START/STOP. Display indicates hundreds of hours.
Flashing display indicates power interruption.
Press any key to deactivate.
NEW BRUNSWICK™ SHAKER OPERATING KEY
M1190-9600 Revision C
12. MAINT: Every 10,000 hours of opera-
tion, lights to signal need for preventative
maintenance
11. SET: For establishment of setpoints,
lights when using or key
10. TIME: Lights during a timed run.
Flashes at end of run.
9. MUTE: Lights when audible alarm is
deactivated.
8. Starts or stops shaking.
7. Increases setpoint for agitation speed
(RPM), time (HRS) or temperature (°C).
1. RPM: Lights when display shows
speed, i.e., actual speed or setpoint in
SET mode. Flashes when 5 RPM above
or below setpoint.
2. HRS: Lights when display shows
time, i.e., actual time remaining, or
setpoint in SET mode, or total running
time.
3. °C: Lights when display shows
temperature, i.e., actual chamber or
bath temperature, or setpoint in SET
mode. Flashes when 1 °C above or
below setpoint.
4. *: Innova 3100 - Flashes when water
level is below setpoint.
5. Determines the Function display:
RPM, HRS, °C
6. Decreases setpoint for agitation speed
(RPM), time (HRS) or temperature (°C).
To adjust running time:
While TIME is lit, press or to set a new time.
1
2
3
4
5 6 7 8
12
11
10
9
SELECT
START
STOP
MAINT
SET
TIME
MUTE
RPM
HRS
° C
*