JLG LSS Scissors - Manual (Page 46)

SECTION 5 - SERVICE - (LE, MRT, RTS, ES, RT)
5-10 – JLG Lift – 3124288
Table 5-5. LSS Module System Interface Connector -
Power & Digital (J1 - Grey)
Pin Signal Description
1 VBAT Positive Power Supply from Host Control System
(12-24V)
2 GND Negative Power Supply from Host Control System
(0V)
3 GND-2 Connects to GND
4 N/C Unused
5 DO1 Overload Indicator Output (Normal=VBAT / Over-
load=0V)
6 DO2 Warning Indicator Output (Normal=0V / Over-
loaded=VBAT for 5 Sec, 0V for 2 Sec)
7 DI3 Unused
8 DI2 Select OVERLD3 Personality Rating (No=0V /
Yes=VBAT)
9 DI1 Select OVERLD2 Personality Rating (No=0V /
Yes=VBAT)
10 GND-2 Connects to GND
11 VBAT-2 Connects to VBAT
12 VBAT-2 Connects to VBAT
Table 5-6. LSS Module System Interface Connector –
Communication (J1 - Black)
Pin Signal Description
1 APWR Pre-Regulated Supply for JLG Analyzer (Analyzer
Pin 1; approx. 12V)
2 TX RS-232 for JLG Analyzer (Analyzer Pin 3)
3 TRP1 120 Ohm CANbus Terminator
4 CANH-1 CANbus Interface High
5 CANS-1 CANbus Shield Termination (Not same as GND)
6 CANH-2 Connects to CANH-1
7 CANL-2 Connects to CANL-1
8 CANS-2 Connects to CANS-1
9 CANL-1 CANbus Interface Low
10 TRP2 120 Ohm CANbus Terminator
11 RX RS-232 for JLG Analyzer (Analyzer Pin 2)
12 GND Ground for JLG Analyzer (Analyzer Pin 4)
Table 5-7. LSS Module Load Cell Connector Pinout (J5,
J6, J7, J8)
Pin Signal Description
1 + Signal Positive Sensor Output (approx. 2.5V)
2 Cal Clock Serial Clock to Sensor’s Integrated Memory
3 - Excitation Negative Sensor Supply Voltage (approx. 0V)
4 +Excitation Positive Sensor Supply Voltage (approx. 5V)
5 - Signal Negative Sensor Output (approx. 2.5V)
6 Cal Data Serial Data from Sensor’s Integral Memory
Figure 5-2. LSS Module Load Cell Connector
Pinout (J5, J6, J7, J8)
NOTE: Physical connector as viewed looking into the
cable end