Echo SRM-225U Serial S79012004906 - S79012999999 - Manual (Page 23)

SRM-225U OPERATION
X7722271408 23
© 3/2014 ECHO Inc.
Starting Warm Engine
The starting procedure is the same as Cold Start except DO
NOT close the choke, and do not hold throttle trigger fully
depressed.
The attachment should not move at idle, otherwise serious
personal injury may result.
Note: If attachment moves, readjust carburetor according to
“Carburetor Adjustment” instructions in this manual or
see your ECHO Dealer.
1. Stop Switch
Move stop switch button (A) forward away from the STOP
position.
2. Purge Bulb
Pump purge bulb (C) until fuel is visible in the “Clear” fuel
return line.
Note: Lightly place knee on drive shaft to stabilize unit during
starting. Do not apply excessive downward force or
damage to unit can occur.
3. Recoil Starter
Lay the unit on a flat area and keep movable attachment parts
clear of all obstacles. Rapidly pull the recoil starter handle (D)
until the engine fires.
Note: If engine does not start after 5 pulls, use Cold Start
Procedure.
Stopping Engine
1. Throttle
Release throttle and allow engine to return to idle before
shutting off engine.
2. Stop Switch
Move stop switch button (A) backward to STOP position.
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall
engine. Have your ECHO dealer repair stop switch before using unit again.
A
C
D
A