Echo 72620 - Manual (Page 12)

6 INCH CHIPPER 8
section
belt engagement pedal: Push the pedal down to
disengage the drive belt. Release the pedal to engage
the drive belt and begin chipping.
chipper feed chute: feed materials to be chipped into
the chute.
discharge tube: the discharge tube can be rotated 360
degrees and locked in place with the lock pin.
engine: See engine controls on next page.
3.1 conTrols
feaTure and conTrols
feed roller control bar: (Model CH6614H only) Use the
control bar to engage the hydraulic feed (see Sec.
4.4)
feed roller jack: Use the jack to raise the feed roller to
clean out a plugged roller (see Sec. 5.12).
fuel tank: Use unleaded fuel–do not mix with oil.
rotor access cover: Remove to access chipper blades.
3
FUEL TANK
BELT
ENGAGEMENT
PEDAL
FEED
ROLLER
JACK
FEED ROLLER
CONTROL BAR
CHIPPER
FEED CHUTE
ENGINE
ROTOR
ACCESS
COVER
DISCHARGE
TUBE
hYdraulic feed model shoWn here