Echo 74554 Owners Manual v.4 - Manual (Page 15)

11 5 INCH CHIpper
Section
Warning
5
serviCe & mainTenanCe
5.2 serviCe and mainTenanCe sCHedule
serviCe and mainTenanCe sCHedule
ComPonenT
mainTenanCe
reQuired
before
eaCH use
everY 8
Hours
everY 25
Hours
everY 50
Hours
everY
200
Hours
hydRAULIC OIL ChECK/FILL
ALL INTERNAL ANd ExTER-
NAL NUTS ANd BOLTS
ChECK TIghTNESS
ChIPPER ANvIL
ChECK CLEARANCE ANd
RE-TORQUE TO 75 FT-LBS.
(2)
ChIPPER BLAdES
ChECK ShARPNESS ANd
RE-TORQUE TO 25 FT-LBS.
(1)
ENTIRE MAChINE CLEAN
PTO CROSS JOURNALS LUBE
PTO INNER TUBES LUBE
PTO ShIELd RETAININg
BEARINg
LUBE
dRIvE BELT ChECK
hydRAULIC dRIvE BELT ChECK
BELT TENSION ChECK
BELT/PULLEy ALIgNMENT ChECK
gREASE zERKS LUBE
hydRAULIC OIL FILTER REPLACE
(1) PERFORM MORE FREQUENTLy UNdER ExTREMELy dUSTy CONdITIONS.
(2) PERFORM MORE FREQUENTLy WhEN ChIPPINg dRy OR dIRTy WOOd.
as the limited Warranty states, failure by the owner to perform normal maintenance will void the machine’s warranty. The aggres-
sive, high-speed nature of chipping reQuires THe oWner To Perform THe above lisTed normal mainTenanCe. special
consideration to maintain and re-torque the CHiPPer anvil, CHiPPer blades, and all inTernal and eXTernal nuTs and
bolTs is the sole responsibility of the owner. failure by the owner to do so shall be cause for denial of warranty.
To prevent personal injury or property damage: shut
off engine and make sure that all moving parts have
come to a complete stop before, servicing, adjusting or
repairing. disconnect the battery and remove ignition
key where applicable.
5.1 mainTenanCe sCHedule
The items listed in this service and maintenance schedule
are to be checked, and if necessary, corrective action
taken. This schedule is designed for units operating under
normal conditions. If the unit is operating in adverse or
severe conditions, it may be necessary for the items to be
checked and serviced more frequently.
see engine oWner’s manual for furTHer
engine mainTenanCe and TroublesHooTing
informaTion.