4 operation safety – Echo LS21160 Owners Manual v.4 User Manual

Page 6

Advertising
background image

2

LOG SPLITTER

SAFETY

1.4 oPERATIoN SAFETY

This machine should be used for splitting wood only,

1.

do not use it for any other purpose.
Allow only one (1) person to load and operate the log

2.

splitter. If a helper is assisting in loading logs, never

activate the control until the helper

is a minimum of 10 feet away from

the machine.
Always operate the log splitter from

3.

the operator zones specified in

Section 4.6.
Do not use any body part, other than your hand, to

4.

operate the controls.
Always stand clear of discharge area when operating this

5.

machine. Keep face and body away from cutting area.
Keep hands and feet out of cutting area while machine

6.

is operating to avoid serious personal injury. Stop

and allow machine to come to a complete stop before

clearing obstructions.

Do not operate this equipment in the vicinity of

7.

bystanders. Keep the area of operation clear of all

persons, particularly small children. It is recommended

that bystanders keep at least 50 feet (15 meters) away

from the area of operation.
Do not allow children to operate this equipment. Allow

8.

only adults to operate the log splitter. No one under

the age of 18 should be allowed to operate the log

splitter.
use only in daylight or good artificial light.

9.

Do not run this equipment in an enclosed area. Engine

10.

exhaust contains carbon monoxide gas, a deadly

poison that is odorless, colorless and tasteless. Do not

operate this equipment in or near buildings, windows

or air conditioners.
Always use an approved fuel container. Do not remove

11.

gas cap or add fuel when engine is running. Add fuel

to a cool engine only.
Do not fill fuel tank indoors. Keep open flames, sparks,

12.

smoking materials and other sources of combustion

away from fuel.
Do not operate machine without shields in place.

13.

Failure to do so may cause serious injury or death.
Keep all guards, deflectors, and shields in good working

14.

condition.
Before inspecting or servicing any part of this machine,

15.

shut off the machine and make sure all moving parts

have come to a complete stop. Disconnect the spark

plug.
Check that all screws, nuts, bolts, and other fasteners

16.

are secured, tightened and in proper working condition

before starting the machine.
Do not transport or move machine while it is operating

17.

or running.

Set up your work site so you are not endangering traffic

7.

and the public. Take great care to provide adequate

warnings.
Never operate the machine on slippery, wet, muddy, or

8.

icy surfaces. The location you choose should be solid,

level, dry, and free from any tall grass, brush, or other

interferences.
Always block machine wheels to prevent unintended

9.

movement and lock in either horizontal or vertical

position.
Ensure the control lever is in the neutral detent position

10.

before starting the machine.
Keep the machine clear of debris and other

11.

accumulations. Immediately remove split wood from

around the machine so you do not stumble over it.
During operation, hydraulic log splitters develop high

12.

fluid pressures. Fluid escaping through a pin hole

opening can penetrate your skin and cause blood

poisoning, gangrene, or death. Keep in mind the

following instructions at all times:

a. Do not check for leaks with your hand.
b. Do not operate machine with frayed, kinked,
cracked, or damaged hoses, fittings, or tubing.
c. Stop the engine and relieve hydraulic system
pressure before changing or adjusting fittings,
hoses, tubing, or other system components.
d. Do not adjust the pressure settings of the pump
or valve.

leaks can be detected by passing cardboard or wood,

13.

while wearing protective gloves and safety glasses,

over the suspected area. look for discoloration of the

cardboard or wood.
If injured by escaping fluid, see a doctor immediately.

14.

Serious infection or reaction can develop if proper

medical treatment is not administered immediately.
Do not attempt to split two logs with one positioned on

15.

top of the other.
Check the logs before splitting. Ensure there are no

16.

foreign materials, such as nails, present in the wood.
Do not attempt to split wood across the grain.

17.

Always make sure that both ends of the log you are

18.

splitting are cut as square as possible. This will prevent

the log from sliding out of position while under pressure.

Logs should be 24 inches or shorter in length.
Do not load the log splitter while the splitting wedge

19.

is moving.
Hold the log by the sides when you are positioning it

20.

into the log splitter. Do not hold the log by the ends.
Always keep your fingers away from any cracks that

21.

open in the log during the splitting operation.

Advertising