ACU-RITE MILLPWRG2 User Manual
Acu-rite, Millpwr
Advertising
Table of contents
Document Outline
- Controls of the MILLPWRG2
- Manual Information
- MILLPWRG2 Access Code
- Introduction
- Machining Fundamentals
- DRO Mode and Calculator
- Tool Table
- Program Overview
- 5.1 Programming Introduction
- 5.2 Program Mode Functions
- 5.3 Creating programs overview
- Programming
- 6.1 Conversational Programming
- Programming Considerations
- Fundamentals for Creating a Program
- Running a Program
- Establishing a Datum
- Overview
- Steps to Establish the datum
- X Axis Datum:
- Y Axis Datum
- Z Axis Datum
- Retract Z
- Using an electronic edge finder
- Setting the datum on an edge
- Setting the datum at the centerline
- Setting the datum at the center of a circle
- Test the Datum Setting
- Testing a MILLPWRG2 Program
- Single Step
- Dry Run
- Graphics Only
- Machining Your Part
- Potentiometer for Feedrate Override
- Manually Positioning the Quill
- 6.2 Folders
- 6.1 Conversational Programming
- Demonstration Program
- 7.1 Demonstration Program
- Overview
- Begin Programming
- Selecting A Tool
- Programming a line
- Programming an Arc
- Programming the connecting Line
- Programming the lower vertical Line
- Programming the lower angle Line
- Programming the upper angle Line
- Programming a Blend
- Closing the contour
- Tool Change for the Bolt hole Pattern
- Programming the Bolt circle
- Tool Change for the Rectangular Pocket
- Programming the Rectangular Pocket
- Testing the Program
- Running the Program
- Tool Changes
- Clearing the Program
- 7.1 Demonstration Program
- Milling and Drilling
- Setup
- Software Update
- Off-Line Software