Allworx 9204G Phones - Manual (Page 20)

Allworx Phone Model 9204/9204G User Guide
Page 12 +1 866 ALLWORX * +1 585 421 3850
www.allworx.com
Revised: 5/21/14
To transfer a call to an external party while in Key System mode, press a free Line
Appearance PFK and then dial the phone number.
If the system is not in Key System mode, continue to step 2.
2. Wait for the dial tone, and then dial the extension to transfer the call.
• Unattended (Blind) Transfer: skip to step 3.
• Attended (Announced) Transfer only: Talk to the recipient.
3. Hang up, press the TRANSFER button, or press the XFER soft key.
To transfer to voicemail:
1. Press the TRANSFER button, and then press the VMAIL soft key.
2. Dial the extension, press a BLF key, or press the Speed Dial key.
3. Hang up, press the TRANSFER button, or press the XFER softkey.
3.2.5 Release
Use the RELEASE button to end an active call or to abort a new call setup, such as the middle
of a transfer operation.
3.2.6 Park
PBX Behavior on a call appearance: To park an active call, press the PARK button. The phone
briefly displays the parking orbit extension of the call.
Key System Behavior on an outside line: To place an active call in a “system-wide hold”, press
the PARK button. Any phone with a PFK for this outside line can retrieve the call.
Pressing the PARK button on a handset displays a list of currently parked calls (including the
Caller ID and number of the parked caller, the parked call orbit number, duration of the parked
call, and the extension number that parked the call). Users may select a call from the list to
retrieve the parked call. If there are no active calls on the handset, the LCD screen displays No
Calls Parked.
Note:
The phone configuration may not enable users to stay on the line to announce the transfer. See
“To do an Unannounced (Blind) transfer :” on page 10. for Announced transfers.