American Lighting ALT2 Series - Manual

These products may represent a possible shock or fire hazard if improperly installed or attached in
any way. Products should be installed in accordance with these instructions, current electrical codes and/or
the current National Electric Code (NEC).
T2 Ultra Thin
Installation instructions for ALT2 Series
WARNING:
CAUTION - To reduce risk of fire, electric shock or injury to persons:
1. This light is intended for indoor use only.
4. Not intended for lighting aquariums.
3. Mount light only to surfaces that are mechanically sound.
2. Do not link more than 10 fixtures in any single run.
5. Use only with factory-recommended linking extensions and hardwire boxes (sold separately). Factory warranty will be
void if used with a non-recommended power component, and/or if any components are altered in any way.
6. Do not use with a dimmer.
MOUNTING T2 ULTRA THIN
Each fixture includes two “U” shaped clips and two 90˚ clips for mounting. See Figure 1.
Note: Select which mounting system is best for the application and installation. Plan fixture layout
in advance when using multiple fixtures to ensure that linking extensions will reach each location.
1. Locate desired position for light. Leave 1” clearance around the fixture for access to end connectors,
On/Off rocker switch and lens cover.
2. For mounting fixtures using “U” mounting clips, mark locations for clips, install each clip with screws
provided and carefully snap or slide fixture into clips. Repeat these steps for additional fixtures.
For mounting fixtures with 90˚clips, slide clips into slots
on bottom of fixture at each. Hold fixture in place
and secure each 90˚clip using a screw gun and the
screws provided. Repeat for any additional fixtures.
3. Use included 3” or 12” linking extension to interconnect
multiple fixtures as needed. 6”, 24” and 48” lengths
are also available (sold separately).
ATTACHING POWER CORD
NOTE: The T2 Ultra Thin is designed to be used in either
plug-in or hardwire applications. For hardwire applications,
you must use a hardwire box (ALSLBOX-WH-B), sold
separately. Do not exceed ten fixtures in any single run.
Each port on the hardwire box accommodate up to ten fixtures linked together. See Figure 2.
1. For plug-in installations, attach included power cord to first fixture
and route cord to nearby 120V AC outlet.
2. Plug into switched outlet or use rocker switch(es) for On/Off functions.
ATTACHING TO HARDWIRE BOX
1. For hardwire installations, follow instructions included with the hardwire box. Installation of the hardwire box
should be performed by a qualified, licensed electrician.
2. Attach linking extension to the first fixture in the run and plug into
one of the molex ports on the hardwire box.
www.americanlighting.com
Figure 2
Each molex port can power up to ten
interlinked fixtures.
RV-1008KB
Figure 1
A hardwire box (ALSLBOX-WH-B) is
required for hardwire installations.