Anchor CENTURY MAXI-GRIP USE AND CARE INSTRUCTIONS - Manual

MX 0811
R3 0512
MAXI-GRIP USE AND CARE INSTRUCTIONS
EC4394
Maxi-grip
Closure Tool
Lever shown in
open position.
Pull Strap.
Upper roller.
Lower roller.
Top of Flap
Left side
underneath Right side on top
Figure 1
Starting at top of fl aps (short loop end), press edges of maxi-grip
together with right side on top of left. See Figures 1 & 2. Mash the
fi rst few inches together.
A few inches below the part of the Maxi-grip that you have just
pressed together, fi t the Maxi-grip closure tool between the right and
left sides of the Maxi-grip with the lever in open position.
Fit the top roller over the right side and the bottom roller under the
left side.
Slide the tool up until it is just below the closed portion of the Maxi-
grip. Close the lever on the tool so that it is mashing the right and
left sides of the Maxi-grip together.
Hold onto the pull strap and pull it down the fl ap for a few inches.
Make sure there is no gap between the part of the Maxi-grip that
was pressed manually and the part that was pressed using the tool.
Continue pulling with the strap until the entire length of Maxi-grip is
fastened.
Caution: Do not slide closure tool over fl aps until fl aps are in-
position and Maxi-grip is over-lapped. Closure tool may pop off.
Anchor Industries recommends the use of 303 Aerospace
Protectant for the care and maintenance of your Maxi-grip zipper
closure system.
Follow these simple Instructions:
• Cover Maxi-grip surface completely with 303 Aerospace
Protectant.
• Remove any and all excess with a clean cloth - wipe dry.
Proper application creates a nice fi nish that repels soiling and
stains.
Alternative product: Dow Corning® HV 495 EMULSION
Caution: When folding tent, take care that Maxi-Grip is not in a
severe kink.
End View End View
Figure 2 Figure 2
STEP 1
STEP 2
Care of Maxi-Grip
Maxi-grip Closure Tool
303 Aerospace Protectant
Closed portion of
Maxi-grip
Lever shown in
closed position.
Figure 3