Anchor CLASSIC SOLID SAFETY POOL COVER GROMMET SETTING - Manual

INSTALLATION INSTRUCTIONS FOR
POOL COVER GROMMETS
Important Note: Anchor Industries has shipped this pool cover without Grommets. The installer is
responsible for insuring that grommet installation follows the guidelines on this sheet so that the
pool cover meets ASTM F-1346.
GS 0810 EC4223
PLACEMENT GUIDELINES
90º OUTSIDE CORNER
DETAIL
NON-90° OUTSIDE
CORNER DETAIL
SINGLE GROMMET ADDITION
MULTIPLE GROMMET ADDITION
Placement Notes:
Grommets shall be spaced 2’-0” apart.
Stop and start the 2’-0” spacing at outside corners
Between 1st and Last grommets or between grommet and
outside corner, spacing shall be 1’-0” minimum to 3’-0” maxi-
mum.
The next grommet around from an inside corner shall be the
remainder of the 2’-0” before the inside corner.
When distance is over the maximum 3’-0”, place a grommet
at center between grommet and corner or next grommet.
See details on this sheet for curves.
For irregular shaped covers, start at a logical point (corner, or
approximate center-line.) 1.
2.
3.
4.
5.
6.
7.