Aquascape Waterfall Spillway (77000) - Manual

(Item #77000)
Waterfall Spillway
Installation Instructions
PACKAGE INCLUDES
Instructions
The Waterfall Spillway is a cost-effective solution to help you create beautiful waterfalls and streams. This
compact, yet extremely strong Waterfall Spillway is positioned at the starting point of the waterfalls. The pipe
from your waterfall pump is connected to the back of the Waterfall Spillway where the incoming rush of water
is diffused by internal barriers. These barriers help calm the water, providing a smooth flowing waterfall
through the front of the spillway. The liner is attached to the Waterfall Spillway using the two rubber gaskets
and retaining nut located on the back of the Spillway.
Item#77000 ©2010 Aquascape, Inc. • All World Rights Reserved
Made In U.S.A.
Aquascape, Inc.
St. Charles, IL 60174 • Brampton, ON L6T 5V7
www.aquascapeinc.com
• Waterfall Spillway
• 2” MPT x Slip
• Instructions
Step 1.
Build Waterfall and stream providing enough liner at the top of the waterfall to wrap over the top of the Wa-
terfall Spillway. For information on waterfall and stream design and installation please visit our video gallery at
www.aquascapeinc.com.
Step 2.
Set the Waterfall Spillway into desired location.
Adjust the height of the Waterfall Spillway to match the starting point of the waterfall. A
bed of gravel can be placed on top of the liner, beneath the Waterfall Spillway to raise the height
of the spillway to the desired level.
The gravel will also provide a suitable base for leveling the Waterfall Spillway. The Waterfall Spill-
way should be level from side to side and tilt forward a ¼ bubble on a 2 foot level.