Atop Technology MB5404D Quick Start - Manual

MB5404D Series
4-Port Modbus Gateway
Quick Start Guide
Version 1.0 August, 2011
This document is intended to provide customers with
brief descriptions about the product and assist
customers to get started. For detailed information and
operation of the product, please refer to the product
user’s manual in the product CD or Atop website.
1. P ACKAGING
Check whether your package contains following items:
◎ MB5404D x1
◎ Quick Start Guide with Warranty Card x1
◎ Product CD x1
◎ 7-pin Screw Terminal Block (2ESDVM-07P) x1
Optional Accessories：
◎ Wall Mount Kit (WMK-B-459) 202EH731000003G
◎ Console Cable (CBL-RJ45(8P)-DB9(F)-90-C) 50891971G
◎ Grounding Cable (GDC-120) 59906861G
◎ Adaptor (ADP-DB9(F)-TB5) 59906231G
◎ Conductive DIN-Rail Kit (CDK-S-459) 201EH731000005G
◎ US315-12(US-Y) Power Adapter 50500151120009G
◎ USE315-12(EU-Y) Power Adapter 50500151120019G
◎ 7-pin Screw Terminal Block (2ESDPM-07P) 50707871G
◎ 7-pin Screw Terminal Block (2ESDVM-07P) 50707741G
2. H ARDWARE D ESCRIPTION
NOTE:
1. MB5404D (RS-232/422/485 DB9 without isolation ),
2.
Press the Default button of MB5404D to reset to the default
value
Figure 2.1. MB5404D Series interfaces
LED Indicators:
Name Color Status Description
Off Power is not connected
Power Green
On Power is connected
Off Ethernet Disconnected
Green
Blinking
Data is transmitting on
Ethernet for 100Mbps
LAN
Orange Blinking
Data is transmitting on
Ethernet for 10Mbps
Off
No data is transmitting on
COM port
COM Green
Blinking
Data is transmitting on
COM port
Off
System is not ready or
halt
RUN Green
Blinking
AP firmware is running
normally
Installation Procedures:
Step 1: Connect MB5404D to power source
Step 2: Connect MB5404D to the Ethernet network. Use a
standard straight-through or cross-over Ethernet cable
Always make sure the PC is on the same network subnet
as MB5404D.
Step 3: Connect MB5404D’s serial port to a serial device.
Step 4: Mount MB5404D to a Din Rail.
3 S OFTWARE S ETUP
Default Network Setting:
Default User Name/Password:
LAN1 IP:
10.0.50.100
User Name: admin
Gateway: 10.0.0.254
Password: null (leave it blank)
Subnet: 255.255.0.0
LAN2 IP： 192.168.1.1
Gateway: 192.168.1.254
Subnet: 255.255.255.0