BAND-IT J05069 Heavy Duty Adapter - Manual

J05069
Heavy Duty Adapter
Document # P35387 rev. H
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
www.BAND-IT-IDEX.com
Page 1 of 2
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
Operating
Instructions
Place Heavy Duty Adapter on nose of BAND-IT Tool, posi-
tioned as shown. Cut-off screw should not extend beyond
bottom of screw block. Line up tool and adapter slots and
tighten two setscrews. Insert BAND-IT Junior or Junior SID
clamp tail into adapter nose through all slots and grip end with
band gripper lever.
Installing a Band-It Junior Clamp
Install clamp over hose assembly. Tension clamp by turning
handle of BAND-IT Tool clockwise.
When properly tensioned, roll tool over hose, backing off
tension handle ¼ to ½ turn only, through course of rollover,
(depending on type and size of hose) until shear hook grips
buckle edge. Tighten knurled nut by hand, securing buckle
tightly between edge of hook and nose of adapter. Place ratchet wrench on hex nut. Operate wrench clockwise
until clamp is sheared. Clamp is now locked and completed.
The finished BAND-IT Junior SID clamp lip lock will be bent upward 90° and have a cut-off edge
(shown in green) that is flush to the edge of the buckle. Edges shown in red with hash marks are
too high or too low and may result in lower lock strength or sharp edges.
1 2
3 4
5
Cutoff
Screw
Screw
Block
Setscrew