BAND-IT Q Clip Installation - Manual

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P13687 rev. B
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
www.BAND-IT-IDEX.com
Page 1 of 1
Q-Band
Installation
Instructions
1. Cut Q-Band to length, allow 2-3
inches of excess material for tool
to grip the band. 2. Fully insert one end of Q-Band
into self-locking lower end of Q-
Clip with ribs facing up until it
stops. 3. Wrap Q-Band around object and
push loose end through higher side
of Q-Clip. Pull though at least 2-3
inches for tool to grip.
4. Tighten with Q-Gun. 5. Cut end flush for a lower profile
or leave long to re-use. 7. To loosen or undo, lift the back
locking section off of band ribs to
release.
Refer to website for warranty information: http://www.band-it-idex.com/warranty.html