COATS Kit 85608159 Inflation Cage Bracket - Manual

85608160 00 07/12 1 of 2 © Copyright 2012 Hennessy Industries and COATS All Rights Reserved
Instructions
Before beginning this modification or attempting
any maintenance, remove the electrical power and air
source from the machine; also, bleed off any stored
compressed air by exhausting through the air blast foot
valve.
1. At chassis end, remove two screws and reserve
the hardware.
Important: Do not remove screw at the far left side
of the chassis.
2. Position cage bracket at chassis end and use
reserved screws to fasten cage bracket to machine
chassis, then secure.
3. Use two 3/8 x 2.5 inch U-bolts and four 3/8-16 nuts
to fasten cage bracket to inflation cage, then secure.
4. Refer to the Tire Inflation Cage Kit 85607770
instructions for its attachment and setup procedure.
5. Reconnect the air and electric supply to the
machine. Test the machine for full function before
returning the machine to operation.
Center Post Tire Changer
Bracket Kit 85608159
For use with COATS EL-X™ Express Lane
Inflation System
Hennessy Industries • 1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 (800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
Position Bracket And
Fasten To Machine
Center Post
Tire Changer
Attach Bracket To
Tire Inflation Cage
Kit 85607770
DO NOT remove the
far left screw.
Remove the middle
and far right screws.