Control Company 5200 WATERPROOF COUNTDOWN TIMER User Manual

Control Company Measuring instruments

Advertising
background image

SPECIFICATIONS

Timing capacity: 99 minutes 59 seconds.

Battery: silver-oxide button cell
COUNT-UP TIMING

The unit counts up to 99 minutes 59 seconds. Once the

timer reaches 99 minutes 59 seconds it starts the timing

over again from 00 minutes 00 seconds.
COUNTDOWN ALARM TIMING

1. Press the MIN and SEC buttons simultaneously to

clear the display to zero.

2. Press the MIN (minutes) button to advance the

minutes digits. Press and hold down the MIN

button to rapidly advance the minutes.

3. Press the SEC (seconds) button to advance the

seconds digits. Press and hold down the SEC

button to rapidly advance the seconds.

4. Once the desired time is on the display, press the

START/STOP button to begin countdown timing.

5. When the timer reaches zero, an alarm will sound.

The alarm will sound for one minute and then turn off

automatically to preserve battery life.

While the alarm is sounding, pressing the START/STOP

button will silence the alarm, stop the count-up timing,

and recall the last programmed time. After one minute,

pressing the START/STOP button will stop the count-up

timing and recall the last programmed time.
MEMORY RECALL

When timing repetitive intervals, the memory function

will recall the last programmed time. This feature

allows the timer to be dedicated to a frequently timed

test. The timer will return to the last programmed time

again and again.

1. Follow steps 1 through 5 in the “Countdown Alarm

Timing” section.

2. When the alarm starts, press the START/STOP

button to stop the alarm and recall the last

programmed time.

3. Press the START/STOP button a again to begin

countdown timing.
CLEARING THE DISPLAY TO ZERO

If an error is made during an entry, press the MIN and

SEC buttons simultaneously to clear the display to zero.

To clear the display to zero when time is running, press

the MIN and SEC buttons simultaneously.
STOPWATCH (COUNT-UP) TIMING

1. Clear the display to zero (simultaneously press

the MIN and SEC buttons).

2. Press the START/STOP button to begin count-up

timing.

3. Press the START/STOP button to stop count-

up timing.
Once timing is completed and the timer has stopped,

press the MIN and SEC buttons simultaneously to clear

the display to zero.
TIMEOUT

The timer may be started or stopped during any running

time by pressing the START/STOP button.
CONVERT A TIMEOUT TO A COUNTDOWN TIME

Once the timing has been stopped, pressing the MIN

or SEC button will increment the display from the point

that it was stopped and will set the timer into countdown

mode. Once the desired time is on the display, press the

START/STOP button to begin countdown timing.

Advertising