Det-Tronics Mac - w/Supercard - Manual (Page 35)

P
OINT
C
ONFIGURATION
P
ROCEDURE
1. Select Point Configuration from the Configure menu.
This brings up the point configurations screen.
A “point’’ is defined as a sensing device and its communication
module. Each gateway supports up to 250 points. Each point has a
unique address, which is set by means of a dip switch located in the
device’s communication module.
If this is a new EagleVision installation to an existing Eagle 2000
network, you can upload point configurations from the existing gate-
way that has been previously configured.
2. Select the point number or name of the device and then select
the Modify button.
or
Double-click on the point or name of the device.
For similar points, select the point number or name, select copy,
select the point number to be configured and then choose paste.
This will paste the complete point configuration requiring only the
address and name to be changed. The configuration number, set-
points, etc. will be the same as the point copied.
Point Configuration ( Á5)
2.22
95-8434
A1791
A1792