Det-Tronics Mac - w/Supercard - Manual (Page 7)

1. Rename the Macintosh hard disk drive “Detector.”
2. Insert EagleVision Disk 1 (P/N 006141-001) into the floppy drive
and double-click on the “Installer” icon.
3. Follow the onscreen directions.
Detector Electronics’ EagleVision software allows any Apple Macintosh or
compatible computer running under MacOS 7.0 or later to access the
Eagle 2000 system and provide configuration and data acquisition ser-
vices via the Eagle communication gateway. This system can also read
and write from a programmable device that supports Modbus RTU proto-
col. The Macintosh computer is referred to as the Operator Interface
Station (OIS). The gateway provides communication between the Eagle
2000 system and the OIS.
EagleVision acts as a Modbus master and can communicate with up to
four gateways by means of serial link(s) utilizing the Modbus RTU proto-
col. If the OIS is connected to a single gateway, the connection is by seri-
al link from the OIS modem port to the gateway. Multiple gateways will
require a multiport serial board or a Modbus multiplexer.
Installing EagleVision Software
1.2
95-8434