Elkhart Brass Scorpion 8394-04 - Manual (Page 9)

6
G. 81242001 Receptacle for Hand-Held Remote Control
(Figure 6) This device consists of a Deutsch HD10 Series nine-
conductor receptacle mounted in an escutcheon plate for attachment to a
pump control panel or other convenient location on the apparatus. Wire
leads from the receptacle terminate in a 10-conductor Packard Metri-Pak
150 Series male connector. If required, a dual 81242001 installation (i.e.
one receptacle on each side of apparatus) can be accomplished with the
use of two 36805000 wye harnesses and a 36804000
extension harness.
Figure 6
Handheld Remote Control Receptacle
H. 81221001 Tethered Handheld Remote Control
(Figure 7) The optional sealed hand-held remote control has a 50’ tethered
nine-conductor cable that attaches to the Receptacle for Hand-Held remote
control (81242001.). The hand-held remote control has controls to operate
the right/left, up/down, and fog/straight stream operations of the monitor.
This option allows the operator to obtain a better viewing position for
directing the placement of the monitor stream.
Figure 7
Tethered Handheld Remote Control
I. 81466001 Auxiliary Battery Pack
(Figure 8) A 12-volt, 12 amp-hr. sealed lead-acid battery pack is available to allow operation
of the monitor in case of vehicle electrical
system failure. These battery packs are also
used as a means to minimize the required
size of conductors routed up aerial ladders
and towers. This is accomplished by
mounting the battery pack near the monitor,
with a small trickle-charge conductor to the
battery from the vehicle system. Optional
harness lengths of 1’, 3’ and 6’ are
available.
Figure 8
Auxiliary Battery Pack