Elkhart Brass Sidewinder (Aluminum) 8492-02 - Manual (Page 4)

2
II. I
NSTALLATION
I
NSTRUCTIONS
Apply an appropriate thread sealant to the 2” NPT male thread or nipple.
Thread the monitor base onto the male thread or nipple and tighten
securely. Install nozzle onto 1.5 NH threads on monitor discharge. (use
of a stream shaper is recommended when using a smooth bore nozzle.)
III. O
PERATING
I
NSTRUCTIONS
Turn both left/right and up/down lock handles counterclockwise to
disengage locks. Use the tiller handle to direct the monitor discharge.
To secure the monitor in a desired left/right and up/down position, turn
both lock handles clockwise to engage locks. The monitor must never be
left unattended with out engaging both locks.
IV. M
AINTENANCE
& I
NSPECTION
The monitor should be inspected regularly. Careful inspection for damage to
the monitor or nozzle is especially important after use in emergency
operations.
Flow water to check nozzle pattern. If pattern is disrupted, remove nozzle and
check for debris lodged between the nozzle stem and body, or in the stream
shaper inlet.
During nozzle flow test, inspect monitor swivel joints for leaks.
Note:
Although grease fittings are provided for the up-down and left-right
rotation joints, routine greasing should not be necessary. If the monitor is
exposed to a high level of radiant heat for a prolonged period, it may be
possible for the factory grease to thin and run out. In such an event, fresh
grease should be applied. Pump fresh grease into each rotation joint until the
old grease is purged and fresh grease comes out. Rotate the joint 45 degrees
and repeat until the entire range of movement has been covered
V. P
ARTS
D
RAWINGS
Please visit the Elkhart Brass website for parts drawings of both monitors.