EUCHNER MGB-L2-xxxAPx-xxx - Manual (Page 12)

12
Operating Instructions MGB-L1...AR.-... / MGB-L2...AR.-... and MGB-L1...AP.-... / MGB-L2...AP.-...
6.7 Escape release (optional)
The escape release is used to open a locked safety guard from the inside without
tools.
When release monitoring is active, the system enters into a latching fault when the
escape release is actuated.
See System status table, signal sequence incorrect status (DIA red, Lock flashes
1 time).
The system might not enter into a latching fault if the escape release is actuated
very slowly.
Important:
Ì The escape release is not a safety function.
Ì The machine manufacturer must select and use a suitable release (escape
release, emergency unlocking, etc.) for a specific application. A risk assess-
ment appraisal is required for this purpose. It may be necessary to take
specifications from a product standard into account.
Ì The correct function must be checked at regular intervals.
Ì Please observe the notes on any enclosed data sheets.
Ì Fit escape release such that operation, inspection and maintenance are pos-
sible.
Ì The actuation axis for the escape release must be inserted min. 10 mm into
the handle module. Note the information on the different profile widths in the
next section.
Ì Align escape release axis at right angles to the handle module. See Figure 4
and 8.
Preparing escape release
(Also see Figure 7 on the next page)
Profile
width
Length required for
actuation axis
Which EUCHNER parts are
required?
Necessary work steps
Without
plates
With
mount-
ing
plates
(4 mm
each)
D D+13 D+21
30 mm 43 mm 51 mm Standard escape release with
110 mm actuation axis
(order no. 100465)
Shorten to required length
40 mm 53 mm 61 mm Standard escape release with
110 mm actuation axis
(order no. 100465)
If necessary
extended actuation axis (order
no. 106761)
Without mounting plates:
No
With mounting plates:
Use long actuation axis and protec-
tive sleeve and shorten to required
length
45 mm 58 mm 66 mm Standard escape release with
110 mm actuation axis
(order no. 100465)
and
extended actuation axis (order
no. 106761)
Use long actuation axis and protec-
tive sleeve and shorten to required
length
50 mm 63 mm 71 mm Standard escape release with
110 mm actuation axis
(order no. 100465)
and
extended actuation axis (order
no. 106761)
Use long actuation axis and protec-
tive sleeve and shorten to required
length
DIP OFF
ON