Great Northern Popcorn 4104 GNP 11 Roller Cover - Manual (Page 3)

Hot Dog Roller Cover Assembly (Cont.)
Copyright © 2012 DTX International
3
1) Remove the four screws, two on each side,
from the top inner area of the hot dog roller.
See figure 1.
2) Place the back side glass mount (C) onto the
machine and reinsert the screw. Do not tighten
down the screw at this time because we may
need to move it forward of back in a later step.
See figure 2.
3) Repeat step two for the other side rear glass
mount (F) and the two front glass mounts(D&G).
Remember not to tighten down the screws just yet.
See figure 3.
4) Place one of the glass side panels (A)
into one set of glass mounts. The mounts
may need to be moved forward or back to get
a snug fit. Once the fit is snug you may tighten
down the screws to hold the glass securely.
Repeat for the other side. See figure 4
Figure 1
Figure 2
Figure 3
Figure 4