Great Northern Popcorn 4104 GNP 11 Roller Cover - Manual (Page 4)

Hot Dog Roller Cover Assembly (Cont.)
Copyright © 2012 DTX International
4
5) Slide the curved top glass (B) into the
rear side glass mounts and push all the
way down.
Ensure the edge of the curved top glass
and the edge of the side glass are flush.
See figure 5.
See figure 6.
If the glass seems too snug you may need to
loosen one of the screws holding the rear side
glass mounts. Once the top glass is in place,
tighten the screw back down again.
Figure 5
Figure 6
Figure 7
Figure 8
6) Set the front stainless trim rail (E) onto
the edge of the top glass. Ensure that the
holes in the ends of the trim rail line up with
the holes in the top corners of the side
glass (A). See figure 7.
7) Finally, secure the front stainless trim
rail to the side glass with the nuts and bolts
(H). See figure 8.
NOTE: Be sure to NOT over tighten the nuts
and bolts, as this might crack the glass.