Heidolph Pump Heads - Manual (Page 47)

I E I
47
2.2. SP standard, SP vario, (fig. 24)
-
Installation of SP standard and SP vario
pump heads needs flange (9) from your
hardware kit.
-
Uninstall flange (9) from pump head (3)
by loosening setscrew (10).
-
Introduce SP standard or SP vario pump head into flange (coupling pointing forward).
-
Make sure that coupling fits counterpiece (as required, rotate rotor a little bit; remove cover to
get access (also refer to chapter 3.5)). Check horizontal location of pump head (3); tubes
outlet pointing to the left; secure in place with setscrew (10).
-
10
11
9
3
9b
-
Position flange at the front panel by
utilizing the included centering device
(9b). Put the centering device into the
opening of the flange.
Secure flange on front panel with
knuried screws (11). After this, centering
device can be removed.
fig. 24